By using the up-counter, the effective playing time (without the pauses) will be measured. We recommend to operate the iPhone with a charger to prevent the battery runs out during the measurement.Ī popular application is the measurement of music during the practice of instruments. Thanks to the dynamic volume adjustment even quiet sounds, such as snoring, can be measured, and during the night, the total duration of snoring can be recorded. Other sounds such as dogs barking, lawn mowers or even snoring can be detected and the duration time can be measured. The up-counter can be used for measurements of aircraft noise and vehicle noise. The measurements can be interrupted and continued by Start and Stop buttons. All recording times can be reset individually.Īn intuitive generous display indicates whether noise is being measured by a green pulsating speaker. Parallel to the recording time, the total time of forward and backward counting is measured. Thus, the duration of very quiet and very loud sounds can be measured selectively. The volume level can be adjusted dynamically. A countdown timer can be set, and when sounds are detected, every second is counted. If noises are detected over a selectable volume, the counter starts and it can be determined how long the noise and sounds are occurred.Īn up-counter counts up when sounds are detected. Sound Control detects the ambient noises and sounds using the built-in microphone of the iPhone/iPod touch. Im just glad I finally got this to work on this machine.Measure the time of music, sounds and ambient noise It's weird to me that the built in speakers have to be the master even when you have a whole separate audio interface set-up in there. And if you also use an interface and studio monitors for listening, you can just turn the built-in speakers down using system preferences so that you're not hearing two sets of speakers. That'll make them the master source and bring them to the top of the list which form some reason is a crucial element to this working. So if you're still having the problem where you're getting no audio and everything seems to be set up properly, maker sure you go into Audio-Midi and redo the checklist starting with your Mac / built-in speakers. I was looking at AethersHill's response / checklist and realized I didn't really put too much stock into making the Mac Speakers the Master Device as its never mattered before and I've always used my studio monitors and mixer for listening so they were never selected anyways. I used system preferences > Sound to turn the Mac speakers down all the way so that the sound is coming from only my Audio mixer and Studio monitors and Blackhole is sending it to OBS. Then I just checked the Blackhole box and the box for my audio mixer and they all came alive. I unchecked all of the devices and then selected the Mac speakers first so they went up to the top of the list and audio started coming through them. But I realized the order in which you select the devices matters. I have an audio mixer connected to my computer and was also selecting the Mac speakers in the multi output device but still not getting any audio at all. I wasn't getting any audio at all after creating the multi-output device using Blackhole and my main speakers. I wanted to post this because I was having the same problems.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |